- PowerGrip
- Part No: T981
- Material: Polychloropren (neoprene)
- Colour: Black
- Number of teeth: 107
- Width (mm): 25
- Length (mm): 856
- Qty: 1pc
- Suitable with:
- CHEVROLET SPARK
- Petrol 1L/49KW 1.0 SX LQ4(61CUL4) Front-Wheel Drive Hatchback (05/05-04/11)
- Petrol 1L/46KW 1.0 SX LA2,B10S Front-Wheel Drive Hatchback (05/05-on)
- Petrol 1L/47KW 1.0 G 10 CV M150 Front-Wheel Drive Hatchback (11/02-12/04)
- MITSUBISHI LANCER
- Petrol 1.6L/75KW 1.6 ClearTec CNG 4G18 CG,CH,CJ,CS_A,CT_A Front-Wheel Drive Sedan (03/08-08/12)
- Petrol 1.5L/74KW 1.5 4G15 (16V) CJ_,CP_ Front-Wheel Drive Sedan (06/00-08/03)
- Petrol 1.6L/77KW 1.6 (CS3A) 4G18 CG,CH,CJ,CS_A,CT_A Front-Wheel Drive Sedan (06/00-09/10)
- Petrol 1.6L/81KW 1.6 4G18 CG,CH,CJ,CS_A,CT_A Front-Wheel Drive Sedan (07/05-08/12)
- Petrol 1.6L/72KW 1.6 (CS3A) 4G18 CG,CH,CJ,CS_A,CT_A Front-Wheel Drive Sedan (09/03-12/13)
- Caution:
- Before any service work on the belt is begun to be sure that the motor or engine is switched off and cannot be started.
- Important:
- Check for worn tensioners and idler pulleys. This is the best time to replace these part these parts if needed.
- Belt Removal:
- Loosen adjustment or pivot bolts.
- Move adjustment unit to minimum position.
- Remove belt.
- Belt Installation:
- Place new belt loosely on pulleys. Do not pry onto pulleys.
- Tension belt according to manufacturer's instruction.
- Run drive 5 minutes and retension. Belts must be tight enough to prevent slipping when drive is fully loaded.
